How to Switch Out a Kitchen Sink

Thảo luận trong 'Tin tức y dược'

Quảng cáo trực tuyến admarket, Truyền thông trực tuyến, 08/09/22: https://8888bong.com/, https://www.188bongda.net/
  1. TerenceRoache

    TerenceRoache New Member

    Bài viết:
    1
    Đã được thích:
    0
    One of the most important things to remember when switching out your kitchen sink is how to turn off the water supply to the sink. There are two separate valves that should be turned off separately for hot water and cold water. Then, you should shut off the cold water valve and test the water flow. A few drips are normal. Leaving these valves open will release the pressure that is in the lines. Afterward, turn on the faucet and drain the water from the old sink.


    Turn off the water supply

    Turn off the water supply to the old sink. Most supply lines have a shutoff valve, but if the tee connection is too high, the new one will not drain properly. In this case, you must turn off the water supply to the entire house. Once you're done, turn on the faucet to drain the old line and release trapped pressure. Next, install the new sink. Once you have the new one installed, you can start using it.

    Remove the drain

    You'll need to remove the drain assembly, which will need to be disconnected from the floor drain and tailpiece. Use a saber saw to cut out the outline of the sink. After cutting out the template, lift it up and place it into the new position. If you have a metal drain line, you'll need to lower the sanitary tee connection inside the wall. Plastic tee connections are easier to work with, but they can also be a little more difficult to get to.


    When installing the new sink, you'll need to turn off the water supply to the old one. While this may be a small task, it's still vital to make sure that the water line is completely shut off before you begin work. Before starting, remember to turn off the power to the garbage disposal to prevent electrical shocks. Once the power is off, it's time to reconnect the drain pipes to the new sink.

    The first step in switching out a Kitchen white granite sink is to remove the drain assembly. Once you've removed the drain assembly, you can now switch out the new one. After the installation, you'll need to remove the old mounting system. You'll need to use a saber-saw to cut the holes. Once you've removed the old sink, you need to disconnect the drain line from the sink.


    Disconnect the drain pipes

    Depending on the new sink you're replacing, you may have to disassemble the old one first. Before removing the old sink, be sure to disconnect the drain pipes. Then, disconnect the waste arm and floor drain. Take note of the size of the drain tubes and sanitary tee connections. You'll also need to remove the drain pipe. Taking away the drain tube can make the entire process easier.
    Đang tải...

Chia sẻ trang này